I tried looking through past posts, however with all the BIOS issues with Ryzen 3 it was difficult to locate any Tomahawk posts not about that and even harder for issues with fans themselves. I've tried the different settings for the fan controls but they all are spinning at about 1000rpm when temps are mid-30C.Īny suggestions on how to get the fans to act properly where they only ramp up that high when temps start to get higher to help lessen the noise would be much appreciated. I do not have a fan controller but will get one if I need too, however would like to try and get this under control without doing that. I have MSI tomahawk b450 max and it has 4 x 4-pin system fan connectors and 2 x 5050 RGB LED strip 12V connectors. I do have them connected with splitters to the fan connectors on the board. Basically, I want to add RGB fans to my pc. Prior to setting a fan curve in BIOS they where all ramping up to about 1500rpms. All of my case fans are 4pins, specifially these fans and am having a hard time getting their speed under control. Recently upgraded from a Gigabyte b350 to b450 Tomahawk.
0 Comments
Leave a Reply. |